Small amps, big power
JL Audio's HD Series amplifiers offer high performance from an ultra-compact chassis. These Class D amplifiers use less power, take up less space, and generate less heat than traditional amp designs — you can even stack them up to create a sweet-looking installation.

JL Audio technology goes to work for you
HD Series amplifiers reproduce your music with exceptional accuracy, so you'll hear high-fidelity sound even under the most demanding conditions. JL Audio uses Single Cycle Control™ technology to eliminate the excessive signal distortion that's plagued Class D amplifiers in the past. Differential-balanced inputs eliminate noise before it hits the preamp stage, and allow you to connect the amp to just about any in-dash stereo. You'll hear clear, true, studio-quality audio, exactly what you expect from JL Audio.

Power your entire system with one compact amp
The 5-channel HD900/5 amplifier pushes 100 watts RMS per channel to your front and rear full-range speakers, plus 500 watts RMS to a sub — all from a 2" tall chassis that's about the size of a sheet of computer paper. Or, you can bridge the front and rear channels to drive 150 watts RMS into two speakers, while still running your sub at 500 watts. .
The regulated power supply allows this amp to deliver its rated power to a wide range of impedances, even when voltage levels drop during heavy use. Removable power and speaker plugs make it easy to pop this amp out if you need the space.

5-channel amplifer
100 watts RMS x 4 at 4 ohms + 500 watts RMS x 1 (at 1.5-4 ohms)
75 watts RMS x 4 (at 1.5-3 ohms) + 500 watts RMS x 1 (at 1.5-4 ohms)
150 watts RMS x 2 bridged (at 3-6 ohms) + 500 watts RMS x 1 at (1.5-4 ohms)
variable high-pass filter on front and rear channels (50-500 Hz, 12 or 24dB/octave)
variable low-pass filter on subwoofer channel (50-500 Hz, 12 or 24dB/octave)
subsonic filter on sub channel (24 dB/oct at 30 Hz)
removable power and speaker plugs
optional wired remote for level control
Class D amplifier design
MOSFET power and output stages
differential-balanced inputs eliminate noise from your vehicle's electrical system
speaker- and preamp-level inputs (speaker-level input requires an optional adapter)
preamp outputs
4-gauge power and ground leads and a 60-amp fuse recommended — wiring and hardware not included with amplifier
no onboard fuses — when installing multiple amps in a system, an additional 60-amp in-line fuse between the distribution block and the amplifier is recommended
10-3/4"W x 1-15/16"H x 8-5/16"D

Mega-watt have been using JL Audio in our own cars for 15 years and have used JL Audio in most of our IASCA winning cars, we have huge experience and extensive knowledge on all JL Audio products. Call 07775 165 379 for expert advice.